Leaderboard

The company manufacturing them promised they would be ready on April 29th. As soon as I have an update, I will communicate it.

Good info but modifying the std tap with Viton orings seems a more elegant solution. There's enough pipes and connections under the tank as it is for mine. I really dont want any more. Phil

I put two instead of 1+, since I set a counter that can only count numbers and not alphanumerical characters....

Another couple of months to see this sign again! Some of the best roads in the country up in this area! Now I recall we spent the night in Lowell at the Wilderness Motel & Cafe. Fond memories of a delicious Huckleberry milkshake there that night! The scenery is amazing...fresh air, curvy roads, forests everywhere. Just paradise!

When the curve ahead turns into a hairpin and the road turns back against itself, then you know your having a good time !!!

Monday morning update. I successfully replaced all of my fuel line clamps with actual FI clamps. So now my leaking hoses are taken care of, my new riser handlebars are installed, and my newly fitted Andreani forks are ready. So I crank the ignition, it starts for a moment or so then dies. I crank until the battery is dead. I charge the battery and upon retrying to start it, I notice I never unplugged the fuel line to the regulator. I immediately realize the worst of it. By repeatedly cranking a plugged line, I blew the fuel pump. Ordered a new one, due here in a week. #fail

I received the Snugs-Moto and did a quick test run to Louisiana and back! I can only be dithyrambic about the experience. You can see they are personalized with my name engraved in the molding. 1st, they address the wind noise problem because they are before all plugs. Also, no more of the interference with the audio from said wind noise. You get crystal clear audio. I don't listen to music when I ride, only to the audio guidance from the GPS. My phone remains in my pocket. Now, I think Snugs-Moto have a very good setup, perfect for my application. No contraption on the side of my helmet. Although, I made a mistake while wearing them. I had left the speakers of my "Sharktooth" installed, and they pressed on my ears, which made the helix painful against the cartilage. I also had two disconnects: one with a seamless immediate reconnection, the second one, I had to stop and do a power off and on cycle to reconnect. The controls are on the "open dog collar", and not as easy to reach and manipulate as the Cardo and Sena that sit on your helmet. But as I don't use the controls other than before and after the ride, it is not an issue for me. Yesterday, Saturday 20th of April, I went to CycleGear and tried various full face helmets with the Snugs-Moto. I realized that they were much more comfortable, and I could not feel the Snugs while in them. So I removed the speakers in my Shark full face, and no more issue. Also, I don't think they are a mesh system. You would not be able to communicate with a pillion or other riders as other comm. allow.

Just got this message from Ken: "We have 3 rooms open from [September] the 6th to the 8th. All are "standard" and priced at $129.00. Thank you so much for sharing! I have your flag ready to hang!"

You may like this video;

And more, from our member @OzMatt: https://mgprotos.com/

These are what you use on FI hoses. Norma cobra clips. Compact, easy to install, easy to remove, re useable, stainless steel, bullet proof sealing, colour banded for size identification. They sell a special tool to install them but it's not required in reality although I made up one using an old worn out pair of combination pliers for convenience sake. Purple banded size is what you need on 5/16 FI hose. I've been using them for many years and they work perfectly and look compact, professional and tidy. Worm drive clamps are horrible shit looking things. Bulky and just awful to look at. https://www.iq-parts-shop.com/en/norma-cobra-hose-clamp.html Phil

Well, ok.. I'll photobomb you.. We were in the path of totality, so had a cookout/eclipse party. My last apprentice, Austin..now the Indiana MGNOC rep, took these pix. As we approached totality, I went to the house and got my birding binoculars. It "appeared" that we could see eruptions around the corona. The temp dropped 12 degrees, colors changed, and the breeze we had been having dropped to dead calm. Crickets cricketed. I thought, "I wonder what it would look like from the air?" Quickly opened the hanger door, did a preflight, grabbed my flying jacket, silk scarf, and aviator cap, kicked the tires and lit the fires. The spring greens were a different shade, and it looked like a wall of rain 2 miles to the west. The above picture is looking west. When we got there, though, it still looked like rain ahead. Not a ripple in the air. Awesome. You can see some of the effect in this picture taxiing in. Shadows appeared to be cut out of cardboard, and the colors were still "off.: Truly a once in a lifetime experience.. it was good for me.

Ok Thanks for the insights. I have gone back and checked. It seems the play is between the gearbox and the output shaft. The UJ seems to be fine! Thanks again, Paul.

Speaking with the seller in Florida. Guzzi 1947

At some point, @Guzzi 1947, a dedicated thread with this Tenni joining your alluring stable (with pics!) would be most welcome . . .

In discusssion on the bike. Many thanks for the lead.