Hi all
I've just fitted a new set of clutch plates and intermediate plate to my 00 v11 sport, no problems there, plates where from Stein Dinse. Put the engine back in, clutch is solid at the lever. Engine out check everything is as it should be, top hat in clutch centre is present, push-rod is free, pulled slave cyl of, no apparent problems there. Piston is free, pushes out hydraulically and back by hand. Engine back in, still the same.
It feels like the piston is reaching the end of the travel in the housing, before the push-rod can exert pressure on the clutch centre. If I wasn't using the original push-rod I would say it was too short. Has anyone else come across this problem, and if so how did they cure it?
Cheers Gary