-
Posts
4,518 -
Joined
-
Last visited
-
Days Won
234
Content Type
Profiles
Forums
Events
Gallery
Community Map
Status Updates posted by Lucky Phil
-
Personally Pete I'd repair the one you've got. The Spare gearbox I had and used on my V10 engine swap showed no outward signs of cracking but I dye pen checked it anyway and it was cracked. I suspect they crack due to thermal cooling after casting and then it's just a matter of time. Buying a second hand one you run the same risk. Repair is pretty straight forward if you know a good alloy welder. I did mine. Just grind out the crack and pre heat the case to 150C and weld it. Peen it once at the half way point and again at the end. No distortion observed and now it's stronger than the original. I documented it all in my V10 Daytona engine swap thread.
Phil
-
Hey Meinolf any advice on the fuel mapping for the V11/Daytona before the initial start? Is there any fuel maps available that are better than the std V11 map to begine with?
Ciao
-
Hey Pete the breakout connector arrived today, thanks again.
Donation made to Medecins sans frontieres
Phil
-
Hi mate, what do you want for the rear drive unit (bevel box). I would need to ship it USPS as I'm in Australia.
Thanks
Phil