Jump to content

Search the Community

Showing results for tags 'bearing'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • Nuts and Bolts: technical questions and topics
    • Technical Topics
  • Reference Section: techniques, procedures and FAQs explained
    • Frequently Asked Questions
    • How to...
  • Moto Guzzi V11 Le Mans: the ride starts here
    • 24/7 V11
    • Special place for banter and other silly remarks
    • Meetings, Clubs & Events
    • Travel & dealers
    • V11 Registries
  • Other Moto Guzzi Models: current bikes and pre-V11 models
    • Newer models
    • Older models
  • About This Site: adverts, housekeeping and site development
    • Classifieds

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start



Website URL


My bikes





Found 3 results

  1. Hi everybody! I'm new to the forum, I have been reading a lot since i bought my V11 Ballabio this summer. Found lots of very handy info for my new bike. It's winter time here in the Netherlands so im doing some maintenance on the bike. Previous owners did not really give it a lot of ''love'' to say the least. Not all is bad! went over the major things and found nothing shocking so far. Today I took off the rear wheel in order to clean, inspect and lube components such as bearings, U-joint the lot. I found this needle bearing located on the RH side of the rear drive housing. The a
  2. I have just pulled the front forks on my 04 Ballabio and on checking the front wheel bearings found one was sticky and the other distinctly lumpy so they need to be replaced. Marked up as NSK 6205 DU. Is there an approved method or tool for removing them or do I simply beat them out? (The BFI METHOD). I presume the bearing is readily available, but would also appreciate sources or alternative numbers. Before I go to knock out the inner race etc, how do you get these things ou as the lip in the wheel is tiny?
  • Create New...