Tom M Posted February 23, 2013 Share Posted February 23, 2013 Joe, The pop rivets that I used are 3/16" diameter (5mm) x 1/8" long (3mm). Stephano, A good IPA always makes wrenching a little less stressfull . Harpoon is good stuff but I have a new favorite... Link to comment Share on other sites More sharing options...
Unkept Posted February 23, 2013 Share Posted February 23, 2013 Joe,The pop rivets that I used are 3/16" diameter (5mm) x 1/8" long (3mm). Stephano, A good IPA always makes wrenching a little less stressfull . Harpoon is good stuff but I have a new favorite... I'm drinking coffee today. I have never drank alcohol, but wrenching on the Guzzi sometimes has me changing my mind about the decision not to drink. Thanks for the rivet size! I'll likely be on that tomorrow. I actually might use a Subaru driveshaft (2.5 inch diameter) as my tube to mold the sleeve back to shape. Link to comment Share on other sites More sharing options...
GuzziMoto Posted March 3, 2013 Share Posted March 3, 2013 Aluminum rivets work fine but may not last. Sometimes vibration causes them to break. I prefer to use stainless rivets from my local boat store. They are a bit pricey, but if it is something you are not likely to be undoing/re-doing any time soon I find the stainless rivets last much longer. Link to comment Share on other sites More sharing options...
NicoNZ Posted March 22, 2021 Share Posted March 22, 2021 Ooh nice thread. Just purchased some TI cans with a couple of small dings. Now to find some PVC pipe and more importantly some IPA. The dents are removed more easily with some throat lubricant I take it! 3 2 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now