Jump to content

Installation Plate holder CATEYE-2 alu black


v11cafe

Recommended Posts

1/Remove the tail plastic cover

2/Remove the original plate holder and the small subframe

3/Install the Cateye plate holder using the included parts

4/ Connect electric cables as shown in the picture.If in doubt or the cable colors of the light are different, using a multimeter in ohm scale check the continuity to find the earth cable (should be close to zero or zero depending on the accuracy and sensitivity of your devise).The other two cables would have bigger values.

For the other two wires in volt meter scale, one would have always current as 2003+ models have no light switch, and the other would show a reading when you apply the brake as it is controlled by the brake switch.

That's all.

 

IMG_0571.jpg

 

IMG_0570.jpg

 

IMG_0576.jpg

 

IMG_0572.jpg

 

IMG_0573.jpg

 

IMG_0577.jpg

 

Tail.jpg

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...