O2 V11 Posted August 27, 2018 Share Posted August 27, 2018 I need a bit of help on how to select neutral with the gearbox selector plate removed. I changed out gearbox selector spring but first time things did not go back properly for me. I could only select first to third gear so back in I went. However I didn't get neutral selected properly before removing the selector plate and now I cannot get the plate reinstalled. Initially even using the clutch I could not move the bike but now I have properly selected a gear, which one I don't know. Whats the best way to find neutral so I can zip it up again? Rob Link to comment Share on other sites More sharing options...
MartyNZ Posted August 27, 2018 Share Posted August 27, 2018 Whats the best way to find neutral so I can zip it up again? Rob Hi Rob,There are a couple of pictures here: https://www.v11lemans.com/forums/index.php?showtopic=20117&page=2&do=findComment&comment=227185 https://www.v11lemans.com/forums/index.php?showtopic=19547&page=4&do=findComment&comment=218290 Check that the rear wheel spins freely, and you should be good. Link to comment Share on other sites More sharing options...
O2 V11 Posted August 27, 2018 Author Share Posted August 27, 2018 Thanks Marty, I must have been trying too hard last time, all it needed was a little movement of one of the selectors and now the wheel spins freely. I need to pick up a couple of replacement circlips tomorrow and we are away laughing. Rob 1 Link to comment Share on other sites More sharing options...
JBBenson Posted August 27, 2018 Share Posted August 27, 2018 This is neutral: 2 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now