Jump to content

Griso service light reset


Tr500

Recommended Posts

Coe eu56 showing on my Griso year 2006 also red triangular light and service. How do I rectify this. 

Manual/ small thick book not informative enough. I have tried putting in code and then deleting, but still no joy. Oil level o.k. . Any advice please

Link to comment
Share on other sites

Others who know these newer models better should be along with good solutions . . .  :nerd:

(I did change your topic title to get some more attention on the matter . . .)

Link to comment
Share on other sites

  • docc changed the title to Griso service light reset

ECU56 is the speedo sensor. Has it been wet where you are or have you recently washed the bike?

Early sensors were prone to water intrusion at the join between the cable and the 'Block'. If you remove it and dry it with a hairdryer and then seal around the join with silastic it may solve the issue. If not buy a new one. They aren't terrifically spendy.

Diagnostic code for Griso is 12425.

 

pete

  • Thanks 1
Link to comment
Share on other sites

As Pete said, the speed sensor can be somewhat allergic to water. When it gets wet it can trigger that code. You can't clear the code until the issue is resolved. Drying the sensor (perhaps with a hair dryer) will make the issue go away. Sealing the sensor better will keep it from coming back.

Link to comment
Share on other sites

  • 5 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...