al_roethlisberger Posted March 25, 2004 Share Posted March 25, 2004 Moto Guzzi V11 Sport/LeMans Shop Stand FAQ*************************************Introduction:------------------Due the unique design of the Moto Guzzi V11 Sport/LeMans engine, frame, and rear swingarm, typical shop or "paddock" stands often do not work well when attempting to service these motorcycles.Although some generic aftermarket stands can and do work with some modifications to the stand, or careful attention to placement, there are currently few stands recommended for use specifically with the V11 Sport.Moto Guzzi Shop Stand:--------------------------------As sold by vendors such as MG Cycle in North America, the Moto Guzzi shop stand is designed specifically for the spine-frame Guzzi models such as the V11 Sport and LeMans. It lifts the motorcycle via the two frame bolts on the bottom of the side-plates, and also includes an accessory "spool" for lifting the front wheel via placement under the front of the oil pan. Once lifted, the bike is extremely stable.This lift, although a bit awkward for first-time users, provides unobstructed access to the entirety of the bike, excepting perhaps the exhaust crossover to some degree. This ease of access is especially valuable for engine and oil-pan access.As of 2004, the cost of this lift is approximately $140USD.Other vendors such as TLM in The Netherlands also have this stand available.Other stands that have been tested by V11 Sport/LeMans owners include stands made by PitBull(especially for a front lift), and hydraulic lifts such as those made by Craftsman. The disadvantage of hydraulic lift stands is that they lift the motorcycle via the oil pan, so access to this area is impossible for maintenance. However, these lifts are very convenient, especially for providing high and level access to other parts of the bike.Care however should be taken with any generic Motorcycle/ATV/Jet-Ski hydraulic jack that it distributes the weight over a broad lifting surface, and not concentrates it in a small lifting area centered on the oil pan, as one risks cracking the pan.V11 Forum Topics:--------------------------Forum Paddock Stands ThreadForum Stands Thread Link to comment Share on other sites More sharing options...
Recommended Posts