Wick

I got my Nero Corsa from Mike Haven several years ago. Beautiful machine. The Ohlin suspension makes the bike ride higher than my Sport Naked. Same with my Cafe Sport. Both bikes have been gone through and resprung to my weight by GMD Computrack down in Georgia. Wick

I'm looking for a left clip-on for a '03 V11 Sport Naked. I'd take a pair if someone has them taking up space in the garage after a handlebar conversion. Wick

Drama aside, it appears that only 2 of three late model V11's I own have the spacer/shim/whatever. Now I get to take all of them apart and see what is going on. Great........... Next thing I know, I'll be holding someone's spindle. Really great............................. Wick

Try his email at edginton@hotmail.com. If you can't get in communication with him, I have the parts. Wick

Todd Haven at MPH, a site sponsor. Wick

Moto International in Seattle. Wick

It is just my opinion, but, cafe bike implies clip-on controls. The other factor is this set up matches my Nero Corsa identically. And, it is still all factory Guzzi regarding the parts. When I picked up the bike from Mike Haven's shop after the mod's, he commented that this was perhaps the best new Guzzi he had ever delivered. This was after he did the first 600 miles on the bike so as to deliver it to me with the first service done. I rode the bike back from Houston to Memphis straight through and never touched a wheel on the interstate. This bike should be a contender for bike of the month, but, I've never taken the time to send photos to Jaap. Thanks to all for your positive comments on my Cafe Sport. It's a special bike in my now 17 bike collection. Wick

My Nero Corsa reset knob was broken on delivery, too. The Cafe Sport's knob still works. I have the new knob for the Nero, but the plastic piece came off leaving the brass insert still stuck to the shaft. Plan to get it fixed next trip to Houston. Wick

MPH Cycles (Site Sponsor) has the bar risers. I've got them on my Nero and Cafe Sport. I also did the MRA windscreen on the Nero. Both parts are of real quality. Wick

I thought that the ecu needs to see several revolutions in the start cycle before it is ready to light off the engine. I use the several seconds of cranking method and don't use the quasi-choke. It only cracks the throttle a bit, like a fast idle. I just increase the throttle until it catches and then back off a bit for the warm up. Wick

Mike Haven modded my Cafe Sport to clip on's with the MPH risers and converted the front fairing to the old style handlebar mounted c.f. windscreen. A Bosch headlight assembly was required to complete the mod. The light that comes on the Ballabio sticks out about a half inch or so and and didn't look right and was replaced. This was done with all factory V11 parts, save the bar risers. I'll be glad to email you some photos, or Greg Field can send you copies of the some I sent him. Todd may have taken some snaps pre-delivery as well. This retro mod to a Cafe Sport is easily done. Just be prepared to pay for the parts and spend some time changing them out. The Haven's at MPH as they say, have been there, done that, and have a very happy customer. Wick

How much were those pipes?? Wick

I think you both are the best Guzzi parts guys on the planet! Wick (infamous parts buyer)

Hi Docc, I'm going to miss another of the raids as I will be at the RA rally at the Biltmore. My guess is that this will be the first and last motorcycle rally there and I don't want to miss it. (Hope not, really) Wick

Hi Todd. Don't mind your reposting photos of the best set-up Cafe Sport on the planet at all. Wick!! (I think my next Guzzi will be a Stelvio fully bagged for rally raids)