Ø10mm dept gauge for acurate shim decision of the timing sensor
I am proud to present these new dept gauges - produced by our Norwegian member Tom Christiansen.
He and me has discussed the best method of deciding which shim thickness should be used for our timing sensor. As the picture shows - I have found a 3/8" bolt and a nut - which should give me a good dept figure. But I was not fully satisfied with this simple tool. Tom produced some better tools - which ha can sell to our member friends.
The timing sensor needs about 0,5 - 0,8mm clearence to
I am proud to present these new dept gauges - produced by our Norwegian member Tom Christiansen.
He and me has discussed the best method of deciding which shim thickness should be used for our timing sensor. As the picture shows - I have found a 3/8" bolt and a nut - which should give me a good dept figure. But I was not fully satisfied with this simple tool. Tom produced some better tools - which ha can sell to our member friends.
The timing sensor needs about 0,5 - 0,8mm clearence to
