Jump to content

renato

Members
  • Posts

    34
  • Joined

  • Last visited

Profile Information

  • My bike(s)
    2003 v11 sport

renato's Achievements

Guzzisti

Guzzisti (2/5)

0

Reputation

  1. 2003 MOTO GUZZI V11 SPORT, PURCHASED NEW IN 2004, ONE OWNER, 14945 MILES, SERVICED EVERY YEAR, USED ONLY SYNTHETIC OIL, HAS STUCCI CROSSOVERS, MISTRAL MUFFLERS THAT WERE CUT DOWN 6 INCHES AND SOUNDS BAD ASS, AND BMC INTAKE KIT, CLIP-ONS REPLACED WITH HANDLEBARS, NEW METZLER M1 IN FRONT WITH ABOUT 200 MILES, BACK NEEDS A NEW TIRE MIGHT NOT PASS INSPECTION, RUNS GOOD AND STRONG, HAS SCRATCHES AS SEEN IN PHOTOS, SHES CLEAN BUT SHES NOT MINT, BLACK ENGINE PAINT COMING OFF MAIN CASE I STARTED TO CLEAN IT TO BE REPAINTED, BIKE HAS FALLEN OVER ONCE BUT NEVER BEEN DOWN RIDING IT SCRAPED THE ENGINE GUARD AND EXHAUST, ONE BOLT BROKEN WERE FRONT FENDER MOUNTS,JUST REPLACED PHASE SENSOR AND RELAYS, DID NOT WANT TO SELL BUT HAVE TO MANY BIKES AND MUST THIN OUT TO MAKE ROOM.....LISTED ON EBAY http://cgi.ebay.com/ebaymotors/ws/eBayISAP...me=STRK:MESE:IT
  2. thankx for the boost, but she's all good thankx to all the help on this site.
  3. hey, got some time and checked the phase sensor by cranking the motor and the fuel pump did not prime after cranking, so i removed it and it was swollen like may be burnt out, tested it got nothing on the meter, purchased a new one installed it and got that great sound out of my cut down mistrals that i love to hear, thankx to all for all your help
  4. pump primes for at least 2 seconds and i will have to check if it still primes after i release the starter button, checked spark with a spark tester, havent got my multi-meter back yet since last week, by the way do you test the sensor with the starter turning?
  5. checked the battery with a yuasa tester,tester says good, multimeter reads 12.58, have not gone as long as 3 minutes, ill give it a try. thankx
  6. finally had time to swap relays, no go, no spark, just the same starter turns motor and all relays clicking now, anyway do you know were i can get a phase sensor for less than $130.00 or is that a good price
  7. Jeez ill send a pic of the hole and the grease gun going in from the rear if i have some time in between fixing my stuff and mowing the lawn and holy bejezus.
  8. No, im going to check what you told me tomorrow with a meter. thankx
  9. today i tried to start it and got no spark at all, i tried all the wires and connectors under the tank i unplugged them and replugged them, starter turns and i hear the fuel pump priming also one relay is clicking but no others? there is 5 relays in a row, tried to look for schematics for a 2003 io see witch is witch but did not find one, only 1999 and 2004,different amount of relays , do you know where i can find one? thankx
  10. i was just thinking about the relays, the only one i hear is the starter/injector relay, im going to try to push them all up and make sure they are all contacting, hopefully this is the fix, till tomorrow, let ya know
  11. yes front u joint, it was a access hole, and i now have no problems greasing it and you do what to grease the rear u joint? i have no problems with that one, now im confused
  12. hey do you have the part numbers?
×
×
  • Create New...