Jump to content

Search the Community

Showing results for tags 'MGS01'.

More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • Nuts and Bolts: technical questions and topics
    • Technical Topics
  • Reference Section: techniques, procedures and FAQs explained
    • Frequently Asked Questions
    • How to...
  • Moto Guzzi V11 Le Mans: the ride starts here
    • 24/7 V11
    • Special place for banter and other silly remarks
    • Meetings, Clubs & Events
    • Travel & dealers
    • V11 Registries
  • Other Moto Guzzi Models: current bikes and pre-V11 models
    • Newer models
    • Older models
  • About This Site: adverts, housekeeping and site development
    • Classifieds

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start



Website URL


My bikes





Found 1 result

  1. https://youtu.be/PMR4jUTGTic Hi Guzzi mates. my MGS suddenly death, just had 64km odo. I tried almost way for ignition start. and attach movie file about this situation. no spark & no spray. I was tested about... *change new battery *change new SEN8I3 angle sensor *change new spark plug *change coil & wire *check fuse *check alternator & regulator (both exclude for engine start) *check ecu relay point, diode check (without relay, directly wire jump) *check ground wire condition *check 12V wire condition & voltage down *run starter motor independent battery powered *SEN8I3 signal check to Osilloscope *Bank angle sensor check (also check pcb & chip burn) Just spark plug it in, and it won't ignite. the plug hole not ignite either when a Insulator(plastic, rubber also) is inserted. I think when the engine turns faster(low registance), the signal reacts. It appears to be blocking the ignition by resistance. But the speed of the starter motor seems to be enough. Something to have a strong restriction, but I don't know why. Is there anything I haven't done? If you have time, I'd like you to think about it together please.
  • Create New...