2003 Tank Retrofit

[al_roethlisberger]

Here is the balance tube installed on the bottom of the 2003 tank.

 

It isn't ideal, as one side(the pump side) is a bit higher as that's the lowest point on the right side of the tank, but it will still "balance" the two sides of the tank to some degree with no "sloshing".... ideally providing access to I guess about 70% of the "isolated" fuel on the left side.

[al_roethlisberger]

Question: What would be the best adhesive(or tape-type-stuff) to use to attach the "Moto Guzzi" emblems to the tank? Obviously something water proof, and low profile would be preferred.

 

Someone mentioned just a few dollops of black RTV, but I dunno... would that hold long term?

 

al

[Mike Stewart]

A good auto paint store should have what you are looking for. It is just a very sticky double backed tape. 3M may be your best bet but ask the salesperson which one works the best. It comes in different thicknesses so if the emblem back is recessed, go for a thicker double backed tape. If you use some type of glue, removal of the emblem will be very hard without doing any damage to the emblem or tank. With double backed tape, some heat and adhesive remover the emblem will just pull off.

 

Good luck,

Mike