Jump to content

Search the Community

Showing results for tags 'v11'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Nuts and Bolts: technical questions and topics
    • Technical Topics
  • Reference Section: techniques, procedures and FAQs explained
    • Frequently Asked Questions
    • How to...
  • Moto Guzzi V11 Le Mans: the ride starts here
    • 24/7 V11
    • Special place for banter and other silly remarks
    • Meetings, Clubs & Events
    • Travel & dealers
    • V11 Registries
  • Other Moto Guzzi Models: current bikes and pre-V11 models
    • Newer models
    • Older models
  • About This Site: adverts, housekeeping and site development
    • Classifieds

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


Website URL


Interests


My bikes


Location


Facebook


Twitter


LinkedIn

Found 29 results

  1. Hello, I'm selling the rear wheel of my 2002 V11 Wheel in is great condition, includes the rotor. I'm asking $300 or best offer Message me if you're interested
  2. Hi I have recently brought a 2000 v11 rosso mandello from a good friend, to cut a long story short I brought the bike in bits to restore/ reassemble but it hadent had the gear box recall done . I tracked down a well known guzzi specialist who was willing to take on the job . I now have the bike reassembled (with the recall being done on the gearbox) but I can’t get it in to 4th gear with out tapping the gear leaver down slightly and then quickly pulling it up . (It is smooth in to 1st , 2nd and 3rd Abd once past 4th it’s smooth in to ,5th and 6th . I have taken the preselector plate off and can change the gears in the box in the correct order by moving the forks and can run the selector plate through all 6 gears and neutral smoothly . But when assembled it’s the same. Does any one have any advice or tips on what could be causing this ? Kind regards Tony
  3. Hi I am looking to see if I can get hold of a v11 6speed gearbox Any help is appreciated kindest regards Tony
  4. Hello Guys, The virus of the V11 is under my skin so I have another question. When I'm looking for parts for my V11 I saw that they are very expensive in some cases or not deliverable anymore. But secondhand is OK in most cases, so the question is from what kind of Guzzis have the same: - engine block, crankcase , cilinders and piston - camshaft, cilinderhead - gearbox - transmission. An exempel is the speedometer unit in the gearbox. What other Guzzi has the same. I know the list of replace units from other brands on this forum, but I could not find a Guzzi comparison Futhermore are there possibilities to mount a big bore or a 4 valve ? Especially from a other Guzzi model? On my V65 I mounted a 4 valve Lario-head and it's running much better. But I can't find 1-2-3 something here in the forum, so I think this is much more difficult . Thanks
  5. Looking for a V11 Sport timing cover (the one with the bosses), if anyone has one...
  6. So i've got a doozy We have here a 2001 Moto Guzzi V11 Sport (40 000klms) running on one cylinder. It originally melted its right side ignition coil and blew a fuse. Myself and the local mechanic thought we had diagnosed our V11 sport and so we've replaced the ignition coil, we ran the bike on both cylinders for about 5 mins at 1500rpm and FZZZZT (smoke emerges) so now we've melted another, our local mechanic has looked through the bike and believed it is now an earthing issue due to faulty wiring. The Idea was that Voltage was going into the Coil, and not enough was earthing, Thus overheating the Coil. He's contacted us just now and no faulty wiring can be found. The only thing i can think of is that our right side ignition coil is rubber mounted fairly loosely where as the other seems rigid, however i was under the impression that the black cable is the earthing cable and the red is the positive feeding the spark? Before we put the third one in we figured we'd ask the question before wasting more ignition coils here.
  7. Bike has 9200 miles, champagne color, is in excellent cosmetic and mechanical condition, mostly original and stock, except. - has factory carbon fiber exhaust - MotoBits adjustable foot pegs (also have the stock pegs) - comes with a red painted alternator cover that matches the 'pork chops' and looks sharp Tires are Continental Contimotion, and still have plenty of life. Bike start, runs and handles great. Just replaced the battery with a new gel battery, flushed brakes and clutch system, and changed the oil (Agip full synthetic). Bike is located near Boulder, CO. I love this bike, but am Selling due to issues with comfort, and plan to get a V7 Guzzi. I can email photos (too large to upload) alanpratt02@gmail.com
  8. On the Site www.kapaza.be i found some neckless hangers. Maybe something for one of you? http://www.kapaza.be/nl/miniatuur-auto-en-motoren/zilveren-hangerje-108608929.htm
  9. looking for a rear rack for a 2002 v11 scura. PM if you have one. or email plexiform@aol.com I NO LONGER NEED A RACK. ALREADY FOUND THIS ITEM.
  10. Update: Whilst I am looking to purchase a Coppa Italia for use in Long Beach California where my son lives I'd be DELIGHTED to find one in EUROPE or anywhere other than Australia where one is/was lurking....Can't imagine the shipping cost from there. Of course I know there's not many around and most are in the States. Shipping to UK or Long Beach won't be a problem. Please contact me on 00 44 1684 575576 or 00 44 07831 879444.
  11. turo

    1997 V11 Sporti

    From the album: My Bikes

  12. Bbennett

    The Ridge

    From the album: V11

  13. *** I noticed the email forwarding service I was using does not work properly. Please email me again at sangoh@gmail.com *** 2004 Moto Guzzi V11 Ballabio in great condition. I bought it from the first owner who bought it new in 2006. Everything works. I took it to Portland past september, and it ran beautifully. Last major service was done at California Speed Sports (http://www.yelp.com/biz/california-speed-sports-inc-livermore) Higher resolution pictures: https://www.dropbox.com/sh/np9bm07r993qhwh/AAC30kv_mmqdUOnnXfTYVI1Ja?dl=0 I have installed the following parts (have stock parts) 1. Rear fender eliminator 2. Ferracci pipes w/ matched PowerCommander by Ferracci 3. CRG bar end mirrors 4. Reusable silicone valve cover gasket (no more blown paper gasket) 5. Angel GT tires (still looks newish) I have these parts/accessories 1. Moto Guzzi center stand (Just the black stand in the following sample photo: http://www.valpolini.com/files/cache/c2a11c725b8f1fbeb7dafaef94d838a4.jpg ) 2. Repair manuals 3. Oil filter remover tool 4. Moto Guzzi rear rack (same rack in this sample picture: http://i200.photobucket.com/albums/aa306/andsterb/guzzi/guzzi.jpg ) 5. Dowco Guardian cover: http://www.amazon.com/Dowco-50124-00-Guardian-WeatherAll-Motorcycle/dp/B000HS1356/ref=sr_1_2?ie=UTF8&qid=1428822957&sr=8-2&keywords=guardian+motorcycle+cover 6. XENA disc lock: http://www.amazon.com/Xena-Intelligent-Security-STAINLESS-XX-14/dp/B0036GNSGS/ref=pd_sim_auto_3?ie=UTF8&refRID=06PAJ90ATBJ6FX5VBTW4 Asking $4000 OBO Cell: 213-265-6281 Email: sangoh@gmail.com http://s1383.photobucket.com/user/Sang_Oh/library/Moto%20Guzzi%20V11
  14. Hi, Anyone have an idea if I can install V11 Sport engine into Daytona 1000? Anybody have done that before? Is the engine's mountings position the same? My old Daytona engine seems to be in dire needs of new parts - lots of them...been thinking might as well find an used engine. In the cafe racer building fever!
  15. I have a pair of porkchop brackets for a 2003 V11 Sport Naked, left side in very good condition, right side paint is peeling off, but otherwise no damage. $100 plus actual shipping for both.
  16. Hello all, I have what I hope is a simple question: under acceleration, is the rear end rotating towards the front of the bike, compressing the reaction rod, or is it rotating towards the rear, stretching the reaction rod? My semi-familiarity with suspension engineering tells me that since shaft-driven bikes want to raise the rear of the body under acceleration, the pinion is trying to "climb" the ring gear, forcing the swing arm down while rotating the rear end housing forward, which would put the reaction rod into compression. If that is indeed the case, would the stretching (tensile) forces be marginal under braking as I suspect? I would greatly appreciate any and all input. Thanks. P.S. I'm sure most of you know that the drive shaft turns CCW, but I just want to add that.
  17. I'm selling the seat off my 1996 Sport 1100. I'm asking $250 but I'm accepting offers. I also put on here my fairing with headlight if you're also interested in that. Send me a message if you're interested and I'll send you some more photos. Thanks!
  18. I'm selling the fairing and headlight off of my 1996 Moto Guzzi Sport 1100 I'm asking $400 and I will consider offers. Send me a message if you're interested and I can email you more pictures if you would like them.
  19. sailing502

    V11 seat

    Looking for a good condition V11 seat for a 2000 V11
  20. Hi, My V11 Tenni recently destroyed the second clutch plate in as many years and I was wondering if anyone knew where I could lay my hands on a new clutch plate? Any help gladly accepted as twin clutch plate is a very expensive alternative... Thanks. Jools
  21. I am parting out a 1998 Moto Guzzi V11 EV California model. If you need a part just let me know I am selling EVERYTHING! I will give you a very reasonable price and we can negotiate from there. Everything on this bike works very well. Please email me with questions or call. Vcycledi@aol.com or 813-300-5068
  22. This is a A Lot of my Moto Guzzi Parts that are FOR SALE V11 Coils $10 V 11 Shaft Protector V 11 Throttle Cable Please email me with questions or call. Vcycledi@aol.com or 813-300-5068
  23. This is a 1998 Moto Guzzi V11 EV California $3500 Clear title Bike is in very good condition Ready for the road!! Please email me with questions or call. Vcycledi@aol.com or 813-300-5068
  24. Up for sale is a near mint V11 Sport located in Williamsburg, VA. Bike has 8000 original miles, new tires 1500 miles ago, always garaged. Comes with the MG V11 stand, carbon screen and seat cowl, service manual and extra seat. Asking $5300. Call Rob at 757 784 8410. Call for pics.
×
×
  • Create New...