Jump to content
PDBoulder

Relay Failure

Recommended Posts

1 hour ago, gstallons said:

Docc's the MAN

Aw, shucks  . . . :blush:

Seriously, everything I've posted about relays, and tune-up, and so many other things, are just complex issues that I learned the parameters and solutions from folks here, and other reliable sources, and made compilations that are (hopefully) easily searched and found.

You guys deserve quality, searchable, and concise threads that keep these V11 on the road and safe. :race:

  • Like 3

Share this post


Link to post
Share on other sites

You kinda just described why you are THE MAN...dude.

  • Thanks 1

Share this post


Link to post
Share on other sites
On 9/3/2019 at 6:17 PM, PDBoulder said:

Hi,

I have a new to me 2003 Lemans that just last week experienced a relay failure. Heading home after work, it was about 98 degF traveling about 80mph and the bike started cutting out, bucking pretty bad. I managed to make it home, about another ten miles. I had just purchased a tank of gas and suspected that I kicked up something in the bottom of the tank that was causing the intermittent cutout. Pulled the pump and filter, replacing the filter. Nope, that wasn’t it. The bike would still cut out. By pure luck I noticed that relays #4 and #5 were very hot. The prior bike owner provided me with several new Omron G8HE-1A7T-R1-DC12 relays. Sure as shit, replacing relay #4 and contact grease solved the problem. The problem is that today on my way home from work in 85 degree weather the new relay failed. At lunch I had put 70 miles on the bike in and around boulder canyon. Bike ran flawlessly. Air temp was about 80deg. I tested the old relay and it tests fine 83Ohm coil, and 0.1 Ohm contact resistance? So, what is the root cause of the relay failure? Is it the female spade connector losing its spring when hot? Oxidation on the blade? The old relay even when the bike had cooled down still failed in slot #4. Any insight would be greatly appreciated.

Paul

It may not be a relay problem, could be a dirty side stand switch allowing relay 4 to drop out resetting the ECU, try removing the stand relay R3 and stuffing a jumper in the socket between 30 and 87. This happened to my 01

  • Like 1

Share this post


Link to post
Share on other sites

Thanks Kiwi_Roy for the suggestion. I followed your write up on tightening up the relay block female disconnects. Relays now fit snug. I ran the bike yesterday, and it ran without fault. However, the outside air temp was only around 85. The failure only seemed to occur when the outside air temp was above 90+. If the problem does come back, I'll try what you just recommended.

Share this post


Link to post
Share on other sites

PD , the second relay complements a good known working system . It is not made to cure anything . It is made to prevent excessive load to the start system .

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...