Colorobo

If it is let me know Thanks

Any ideas for a new plug or lead on parts. i will have to strip back on harness. any ideas

Do you set tps voltage with the engine warm? when scying TB do you set basliine with rod disconnected using air screws?Thanks

So i found most of what i needed, but front caliper bolts? this is for a 97 1100 sport. Also the sequence for front rim? Tighten axel the pinch bolts or visc versa Thanks again Rob Pancake

So my seals are leaking on my 97 the are the White Power can I even say that? Upside down forks. Anybody have a lead on the seals. Thank you Rob Pancake

What tires and pressures you guys runnin?

Thanks.

So what is the best way to bleed off pressure?

thanks

11oo sport injection does not have quick connects under tank.

How do you bleed off line pack on the fuel lines to remove tank? Specifically the line coming to the regulator on the right side of tank?

Need to start on some winter stuff on the 97 sport. Is there a good way to dump the line pack on the fuel lines? Thanks

What pressure are you running on pirelli Angel gt a spec?

The voltage regulator on my 1100 sport get really hot. I mean that it idled for like 7-8 minutes in the garage and I could barley touch it for 10 seconds Opinions please. .

Are they all the same value,for 1100 sport and v11. Get the omiron.

Use same procedures as Lemans? I got a 97 and its running a little rough. runs strong just needs to be polished. I would. assume the values are the same. If this is in the wrong forum I apoligize.By rights it is a v11. Thanks Rob

So is the 1100 sport engine the same as the v11. Except the trans and ecu ect.

Got it It was a balance problem Twinmaxx, Techmate, or electronic balancers are shit, Got Carbmate or tune and it showed they were out. Dont waste your money on electronic buy ananalog they are much more accurate in my opinion. Running like a scalded dog.

Twinmaxx sync tool 100 dollars us shipped lower 48. Brand new still have instructions.

Do you have throttle bodies? If so how much?

Thats what I thought Docc. I think it might be a shaft seal. But why only affect at partial throttle opening. I sprayed starting fluid on bottom of Rh TB and it changed . any opinions. Rob

Raceco specs .008 .010 exhaust. CO at 0.

So after tuning 5 way to sunday, valves set Raceco specs . it runs awsome except for a cough at just off idle to 1/8 1/4 throttle at low speeds. At the same throttle position at 40 50 mph nothing. Tps basline at .157 followed doccs guide. except bypass screws are at 1/2 to 3/4. Idle at 1100. I can put the headers with the crossover in front back on. Will it help. Thanks Rob

If the tps voltage is higher is there more fuel or less. I am still running lean closed air screws and that helped. had them open 1/2 a turn and had a pop cough of idle. Thanks RP

I bought a TDC indicator after the intake valve closed indicator pushed TDC. 30 bucks or so on Amazon.