Kiwi_Roy Posted May 28, 2015 Share Posted May 28, 2015 If your test bulb is low wattage it will glow at near full brightness because the tail lamp will draw too much current. To get around that take the tail lamp out. Link to comment Share on other sites More sharing options...
xbr5 Posted June 1, 2015 Share Posted June 1, 2015 Hi I just thought I would confirm that there was a short at the back of the bike. The routing of the wire for the registration plate light meant that the wire was pinched just behind the bulb holder. I cut the wires re-connected them with bullet connectors, then routed the cable to the side of the obstruction. Now all seems to be ok. Thanks for the advice of where to start looking. Rob 1 Link to comment Share on other sites More sharing options...
Kiwi_Roy Posted June 1, 2015 Share Posted June 1, 2015 Moto Guzzi - making electricians out of riders for over 90 years. Link to comment Share on other sites More sharing options...
docc Posted June 2, 2015 Share Posted June 2, 2015 Moto Guzzi - making electricians out of riders for over 90 years. Sparky and the Wire Nuts . . . Link to comment Share on other sites More sharing options...
stewgnu Posted June 2, 2015 Share Posted June 2, 2015 Moto Guzzi - making electricians out of riders for over 90 years. Damn, I resisted like a gud 'un... Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now