cash1000
-
Posts
467 -
Joined
-
Last visited
-
Days Won
7
Content Type
Profiles
Forums
Events
Gallery
Community Map
Everything posted by cash1000
-
From the album: Cash1000
-
From the album: Cash1000
-
It looks the same as mine When you installed it did you spilt flywheel & clutch? Photos/
-
Yours is quite different. This is the view of mine through the inspection hole on right side of motor I wonder if its typical of the single plate clutch V11
-
I wasn't able to get clutch & flywheel out last night. Its to tight to remove by hand. Thinking I could use a 3 leg puller Thoughts?
-
Got toothed crown off last night It looks fine Photos of both side
-
From the album: Cash1000
-
From the album: Cash1000
-
From the album: Cash1000
-
From the album: Cash1000
-
From the album: Cash1000
-
From the album: Cash1000
-
From the album: Cash1000
-
Thank for the Drawing Doc. So 10 is only the outer layer. The workshop manual mentions alignment marks to use when reassembling normal clutch/flywheel (Needed to ensure timing is correct?). Are there going to be the same for the RM clutch/flywheel? I will be watching out for them and taking plenty of photos
-
Yes the toothed crown is what the starter motor acts on. I will check for cracks tonight
-
Bolts on RM are an allen head type but yes they will need replacing
-
Back of RM clutch -
From the album: Cash1000
-
Yes it is. 20 years a bit late to claim on it? Any idea if I can find out if it's been done?
-
Good point about the screws. I wonder if they are Guzzi specfic or are available from any good fastners supplier
-
No not yet. One step at a time. Picked up locking tool last night. So planning on opening up clutch tonight
-
Before I decide what I'm doing with the gearbox I want to see what condition the Clutch/plate & Flywheel are in. The workshop manual says to remove the alternator first. Any idea why you need to do this? I've borrowed Locking Tool A and with a RAM clutch being 1 piece you don't need Tool B
-
From the album: Cash1000
-
Why don't you need a clutch plate alignment tool if you have a RAM single plate unit?
-
Vince had no problem dismantling the gearbox Unfortunalty he found a bearing had failed Concern is has debris from bearing damaged other bearings Need to decide whether I get Vince to rebuild gearbox or find a 2nd hand box
