What did you do to your V11 today?

[guzzler]

G'day Mick

Yep, back in 2011 the gap on mine was 1.4mm and reduced to 0.7mm!

Cheers 

[gstallons]

The factory manual gives 0.6-1.2mm clearance or 0.023-0.047" clearance. IDK what the hot setup is.

 I would think the 0.7mm clearance is the best.  You want the tooth to be in the center of the bore when measuring this clearance.

Edited 8 hours ago by gstallons

[Pressureangle]

6 hours ago, gstallons said:

The factory manual gives 0.6-1.2mm clearance or 0.023-0.047" clearance. IDK what the hot setup is.

 I would think the 0.7mm clearance is the best.  You want the tooth to be in the center of the bore when measuring this clearance.

If memory serves, (Bendix factory brakes training) *all* simple coil-type inductive sensors are set at .030" +or- .010". 
So that's supported by this spec.