Leaderboard
Popular Content
Showing content with the highest reputation since 05/04/2023 in Images
-
6 points
-
4 points
-
4 points
-
3 points
-
3 points
-
From the album: '03 V11 Lemans
A closer pic of my relays. Replaced the 20+ year old original equipment ones with CIT brand based on a discussion "Best Relay" on the forum. However the 6th H/C starter relay for the starter is a Picker PC782-1C-12S-R-X, NO:30a/14vdc, NC:25a/14vdc, SAE1171, UL1500, ISO8846 and was supplied by Greg Bender with the relay base & wiring....fwiw.3 points -
3 points
-
2 points
-
2 points
-
2 points
-
From the album: '03 V11 Lemans
Sump from the rear drive of my '72 Eldo. The thick black stuff in the sump is liquid moly that seems to be heavier than the 80w-90 gear oil and settles to the lowest point in the rear drive when static. I can't say that it is the whole 20cc's worth of LM that I put in during the last gear oil change because I have already poured some off when I removed the sump just now but it still has a substantial amount.2 points -
From the album: '03 V11 Lemans
I added the HC Starter Relay Harness to eliminate passing high inrush current to starter solenoid through the ignition switch based on some comments I read in the forum. My own current draw tests appeared to be very low/minimal. However, should the starter solenoid become marginal, the higher draw of the solenoid could damage the ignition switch...imho. I bought the HC Starter relay, base, fuse and harness from Greg Bender at This Old Tractor. It is s nice easy install..the relay base slides onto the existing starter relay base, Red to Batt+, Black to Batt-, spade connctors are routed to starter - Female spade to starter, Male spade to exiting starter solenoid feed wire. https://www.thisoldtractor.com/for_sale_wiring_harness_ordering.html2 points -
2 points
-
1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
From the album: '03 V11 Lemans
My Nomar. I was never able to manage the technique of using the Nomar tire bar so I went with the Mojolever (it can barely be seen lying on the edge lift table, white tip hanging off the end of the table).1 point -
1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
From the album: '03 V11 Lemans
Took the Lemans for a quick 50 mile run after installing a fresh timing sensor oring, changing the engine oil, brake & clutch fluids and stopped at Punderson State Park on this beautiful Saturday for a picture.1 point -
1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
From the album: '03 V11 Lemans
Nice July 4th day in Northeast Ohio for a ride out to Eddie's Grill in Geneva On The Lake, Ohio on the Lemans.1 point -
1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
1 point